The CLAPS planter consists of a load bearing section made of 30/10 thick steel, decorated by laser cutting. The inner planter, made out of 20/10 thick steel, is fixed to the structure. On the bottom of the planter there is an overflow hole, made of a steel tubular,...
The Cone Plus Bench Planter is made of 30/10 thick galvanised and polyester powder coated sheet steel. An exotic wooden seat, treated with natural waterproof oils, is placed at 90 degrees on one side of the planter. This seat is supported by a tubular structure...
The Pin Up Planter is made of 30/10 thick cold galvanised and polyester powder coated steel. On the bottom there is an overflow hole made of a steel tubular, section 16 x 2 mm, h 50 mm. Ground fixing is with suitable bolts (not supplied) through 4 10-mm holes....
The Cone Medium Planter is made of 20/10 thick cold galvanised and polyester powder coated steel. The welding is varnished to be not visible. A 30 x 3 mm ring is welded on the top part of the inner perimeter to make the inner edge. On the bottom there is an overflow...
The Cone Small Planter is made of 20/10 thick cold galvanised and polyester powder coated steel. The welding is varnished to be not visible. A 30 x 3 mm ring is welded on the top part of the inner perimeter to make the inner edge. On the bottom there is an overflow...
